Audio Design ESX Q200A Bedienungsanleitung Seite 9

ENG
INSTALLATION
- Mount the device in the car as shown below.
- Avoid any damage or removing of the components of the vehicle like wires, cables, board computer,
seat belts, gastank or the like.
INTERCONNECTION
POWER SUPPLY AND TURN-ON-CONNECTION
The power wiring which is usually installed in on-board car networks is not sufficient for demands of
this device. Make sure that the power wires to GND and to the +12 V terminal has been sufficiently
specified. A cable crosssection of at least 10 mm 2 must be used to connect the battery to the terminals
of the device.
First connect the GND terminal (Fig. 1, 10) of the device to an appropriate ground connection at the
chassis. To ensure a good connection, residue dirt and dust from the connection point. A loose connection
may cause malfunctions or interferences noise and distortion.
Then connect the +12 V terminal (Fig. 1, 11) of the device with the battery by using an appropriate
cable including an in-line fuse. This fuse should be located very close to the battery (Fig. 1, 14); for
safety reasons not more than 30 cm away. Only insert the fuse when the installation, including the
connection of the loudspeakers, has been accomplished.
Then connect the remote turn-on-wire from the headunit (Fig. 1, 12) with the device's REMOTE terminal.
A cable with a cross-section of 0.5 mm 2 is adequate.
AUDIO SIGNAL CABLES
When installing the audio cables between the RCA outputs of the headunit and the RCA inputs of the
device (Fig. 1, 4), the audio and power supply cables should, if possible, not be routed along the same
side of the vehicle. We recommend a separated installation, e.g. routing the power cable through the
cable channel on the left side and the audio cables through the cable channel on the right side or vice
versa. This prevents interferences due to crosstalk into the audio signal.
9
Downloaded from www.Manualslib.com manuals search engine