Troubleshooting - D-Link HSPA 3G SOHO Installations Anleitung

TROUBLESHOOTING

1. HOW DO I CONFIGURE MY DWR-512 ROUTER OR CHECK MY WIRELESS NETWORK
2. HOW DO I RESET MY DWR-512 ROUTER TO FACTORY DEFAULT SETTINGS?
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
4. WHY AM I UNABLE TO ESTABLISH AN INTERNET CONNECTION?
United Kingdom (Mon-Fri) website: http://www.dlink.co.uk FTP: ftp://ftp.dlink.co.uk
Home Wireless/Broadband 0871 873 3000 (9.00am–06.00pm, Sat 10.00am-02.00pm)
Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am- 05.30pm)
(BT 10ppm, other carriers may vary.)
Ireland (Mon-Fri)
All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm)
Phone rates: €0.05ppm peak, €0.045ppm off peak times
4
Downloaded from DWR-512_A1_QIG_v1.00(EU).indd 4 www.Manualslib.com
SetuP AND CONFIGuRAtION PROBLeMS
NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the router using an Ethernet cable.
- Open a web browser and enter the router's IP address: http://192.168.0.1
- Log into the router using the default username admin, the default password is (leave the field blank).
- Once logged in, you can use the wizard to configure the router, or make changes manually.
Note: If you have changed the password and cannot remember it, you will need to reset the
router to factory defaults.
- If you cannot remember your router administrator password, you may use an implement such as
a straightened paperclip to press and hold the reset button on the front of the router for about
10 seconds.
Note: Resetting the router to factory default will erase the current configuration. To reconfigure
your router, log in as outlined in question 1, then run the Setup Wizard.
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- Every PC that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless Network Name (SSID) and encryption key.
- Use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected PC. You will find a dedicated area on the back of this document, this important
information for future use.
- If connecting using a 3.75G mobile connection, make sure that you are within range of the mobile
service provider, and that the service has been correctly configured.
- If connecting using the WAN via ADSL/Cable service, make sure the modem has been enabled/
connected and is operational, and that the service is correctly configured.
teCHNICAL SuPPORt
manuals search engine
DWR-512
2012/4/3 下午 02:04:39