Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wall Mount Installation
note:
The wall bracket is fixed on the back of the appliance.
Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
A.
Select a location that is not prone to moisture
and is located at least 3 feet (1m) away from
combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
Remove the front surround (see "front surround
B.
removal / installation" section).
C.
Have two people hold the appliance against the
wall to determine the final location.
D.
Place the appliance face down on a soft, non-
abrasive surface. Remove the wall mounting
bracket from the back of the appliance by
removing the screws (Fig. 3-1). Set the bracket
and screws aside.
E.
Mark out the location, then mount the wall mounting bracket onto the wall using 6 screws (supplied). This
bracket MUST have the hooks facing upwards and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If
the wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the bracket to
the wall and the bracket is adequately secured.
F.
With the wall mounting bracket installed, have two people lift the appliance up and insert the two hooks
on the bracket into the two slots on the back of the applinace (Fig. 3-2).
G.
Secure the appliance to the wall bracket using screws previously removed in step D (Fig. 3-3).
H.
Check the appliance for stability, ensuring that the bracket will not pull free from the wall.
I.
Reinstall the front surround.
Wall
Fig. 3-2
www.aflamo.com
Fig. 3-1
A x 6
B x 6
Fig. 3-3
5
Werbung
Inhaltsverzeichnis
