Connecting The Wireless Subwoofer - Samsung HW-F450 Bedienungsanleitung

connections

CONNECTING THE WIRELESS SUBWOOFER

The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect
wirelessly) automatically when the main unit is turned on. If the link indicator ( ) does not light when the main
unit and subwoofer are turned on, please set the ID by following the procedure below.
1. Plug the power cords of the main unit and subwoofer into an AC wall outlet.
2. Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.
• The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.
3. While the main unit is powered off (STANDBY mode),
press MUTE on the remote control for 5 seconds.
4. The ID SET message appears on the main unit's VFD display.
5. To finalize the link, turn the main unit's power on while the
subwoofer's Blue LED blinks.
• The main unit and the subwoofer are now linked (connected).
• The Link indicator (blue LED) on the subwoofer is turned on.
• You can enjoy better sound from the wireless subwoofer by
selecting the sound effect. (See page 19)
10
Downloaded from www.Manualslib.com
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will come on after the Link indicator (Blue LED) blinks for 30
seconds.
If you use a device that uses the same frequency (2.4GHz) near the system, interference may
cause some sound interruption.
The transmission distance of the wireless signal between the main unit and sub is about 33 ft.,
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because
the wireless signal cannot penetrate metal.
If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
manuals search engine
POWER
TV POWER
AUTO
SOURCE POWER SPEAKER TV SOURCE
SoundShare
REPEAT
SOUND EFFECT SMART VOLUME
VOL
TV VOL TV CH AUDIO SYNC
TV MUTE TV INFO TV PRE-CH DIMMER
SOUND EFFECT SMART VOLUME
VOL
S/W
MUTE
LEVEL
S/W S/W
MUTE
LEVEL LEVEL
VOL
3D SOUND DRC
PLUS
VOL
AH59-02547B
3D SOUND
PLUS
S/W
LEVEL
DRC