Appendix; Battery Voltage Control Parameters - SUNBEAMsystem Moonray Serie Bedienungsanleitung

Battery Voltage Control Parameters

Onboard available preset charge profiles (Values 2 x for 24V battery system)
SETTINGS
TEMPERATURE CHARGE COMPENSATION
Temp. Compensation Coefficient
Charging Limit (low temp. - max Volt)
Discharging Limit (high temp – min Volt)
BATTERY FAILURE PROTEC. & DISCHARGE WARNING
Over Voltage Disconnect
Over Voltage Reconnect
Under Voltage Warning Reconnect (LCD icon)
Under Voltage Warning (LCD icon)
LOAD/TIMER PORT - LOW VOLTAGE SENSOR
Low Voltage Reconnect (Load port ON)
Low Voltage Disconnect (Load port OFF)
FOUR STAGE CHARGE PROGRAM PARAMETERS
Equalize Charging
Boost Charging
Float Charging
Boost Reconnect Charging
Equalize Duration
Boost Duration
Setting parameter limitations
Over Voltage Disconnect = Charging Limit, Equalize Charging Voltage = Boost Charging Voltage, Float
Charging Voltage = Boost Reconnect Charging.
For a stable setup Float Charging should be 0.4V higher than Boost reconnect charge
- Over Voltage Disconnect > Over Voltage Reconnect
- Low Voltage Reconnect > Low Voltage Disconnect ≥ Discharging Limit.
- Under Voltage Warning Reconnect > Under Voltage Warning ≥ Discharging Limit.
- Boost Reconnect Charging >Low Voltage Reconnect.
WWW.SUNBEAMSYSTEM.COM
BATTERY TYPE
SEALED GEL
-3mV/C/2V -3mV/C/2V
15.0V 15.0V
10.6V 10.6V
16.0V 16.0V
15.0V 15.0V
12.2V 12.2V
12.0V 12.0V
12.6V 12.6V
11.1V 11.1V
14.6V ——
14.4V 14.2V
13.8V 13.8V
13.2V 13.2V
120 min ——
120 min 120 min

APPENDIX

FLOODED
-3mV/C/2V
15.0V
10.6V
16.0V
15.0V
12.2V
12.0V
12.6V
11.1V
14.8V
14.6V
13.8V
13.2V
120 min
120 min
51