Werbung
ENGLISH
Clearances & Installation
Cyl
Equipment required: long philips head screw driver
1. Confirm you have received all necessary parts as illustrated;
2. Insert Burner into base;
3. Align logo so it sits centred between two (2) sets of holes in base;
4. Tip base and Burner on its side and fix the three (3) Glass Support
Brackets from underside using the philips head screw driver;
5. Ensure Glass Support Brackets are firm and tight and set base
upright again;
6. Position Glass cylinder over slots in the three (3) Glass Support
Brackets and push firmly down using even force around the top rim
of the glass. Exercise caution so as not to fracture or damage glass.
mInI t
1. Confirm you have received all necessary parts as illustrated;
2. Fit glass panel with fixing hole located on lower edge into slot in
base;
3. Fix glass panel with screw and washer provided gently from inside.
DO NOT OVER-TIGHTEN!
4. Repeat for remaining glass panels;
5. Insert burner from above into fireplace.
www.ecosmartfire.com
1.
3.
5.
1.
3.
2.
4.
6.
2.
4/5.
Werbung
