Using The Unit; Operation Modes - Pioneer PDA-V100HD Bedienungsanleitung

07

Using the unit

Chapter 7
Using the unit
When a Pioneer plasma television is connected and the HDMI Control function is set, the plasma television's
remote control can be used to perform normal operations on this unit.
When using the HDMI Control function, set the rear panel HDMI CONTROL switch to ON, then use the plasma
television's "HDMI Control Setting" menu to set the television to permit control of the unit.
This unit can also be used as an AV selector, without using the HDMI Control function. In that case, leave the HDMI
CONTROL switch set to OFF.
This unit has three operating modes when using the Pioneer HDMI Control function.
Each of the modes can be ascertained by looking at the status of the HDMI CONTROL indicators.
The unit's operations and operation restrictions are as follows:

Operation modes

PDP Combination Mode
Independent 1 mode
14
En
Operations/Operation restrictions
Operations:
• HDMI Control function used for linked operation with
Pioneer plasma television.
• Change input selections INPUT 1 to INPUT 5 using the
remote control unit furnished with the Pioneer plasma
television.
• Power on/off linked to plasma television using the remote
control unit furnished with the Pioneer plasma television.
• When a video signal is received from a connected input
component, this unit is automatically turned on and the
input selector switched to allow output of the image from
the connected component (HDMI inputs only).
Operation restrictions:
• The INPUT button on PDA-V100HD and its remote control
unit are disabled.
• The component connected to INPUT 6 cannot be used.
Operations:
• HDMI Control function is used to link operations with
input component.
• When a video signal is detected from a connected input
component, this unit is automatically turned on and the
input selector switched to allow output of the image from
the connected component (HDMI inputs only).
• Whether power off can be linked depends on functional
support of other connected components (namely,
whether power off command can be sent from other
component).
• The INPUT button on PDA-V100HD and its remote control
unit can be used to switch the unit's corresponding
INPUT 1 to INPUT 6.
HDMI Control setting
Settings required on this unit:
HDMI CONTROL switch: ON
Settings required on the
Pioneer plasma television:
Set to allow linked operation
with this unit.
Settings required on this unit:
HDMI CONTROL switch: ON