N) Cord Wrap
Thank you and congratulations for choosing the Steam Mop, The Steam Mop is a new way of
cleaning that is effective and far more hygienic than conventional methods. The steam mop
achieves a high degree of hygienic and increasing cleansing power by converting water into
steam using a microfiber floor cloth enhancing absorbency.
When contact is made with floor surfaces, dirt and grime can be eliminated in a matter of
seconds, since the steam mop uses the active power of steam without the use of detergents
or soap, it is environmentally friendly.
When used correctly the steam mop can kill dust mites and some types of bacteria.
To disinfect a specific area. Position the steamer over the area for a minimum of eight
seconds, the steam temperature will reach to approximately 90‐100°C (194‐212°F). Use this
procedure to disinfect floors in bathrooms, showers, around kitchen counters, pet sleeping
quarters, etc.
INSTRUCTIONS FOR USE
The steam mop is designed to thoroughly clean floor surfaces, such as marble, ceramic,
stone, linoleum, sealed (not damaged) hardwood floors and parquet (not damaged).
WARNING: On surfaces that have been treated with wax, the wax may be removed by the
heat and steam action.
1.
Do not use on unsealed or damaged wood floors or let unit stand on any wood floor for
an extended period of time. This could cause the wood fibers to rise. When using on
vinyl, linoleum or any other heat sensitive floors, use extra caution.
2.
Too much heat can melt down glue in the floor. It is therefore recommended that a
sample cleansing be carried out on an isolated area of the floor. It is also recommended
that you check the use and care instructions of the surface from the floor manufacturer
to ensure suitability to steam cleaning.
3.
The steam mop uses tap water. Residents in areas with hard water, should use distilled
water for better performance.
HOW TO ASSEMBLE AND USE
1) Attach head to body.
2) Secure head with the small Philips Head Screw until it is fully tightened.
3) Make the folding handle to be straight, no screw needed