Audiotec Fischer MATCH UP X4BMW-CTR.3 Bedienungsanleitung Seite 8

Dimensions
UP X4BMW-CTR.3:
*All dimensions are noted in mm
Installation
Removal of the center protective cover
In order to install the MATCH speaker in the origi-
nal mounting position it is mandatory to remove the
center protective cover.
If you are uncertain how to remove the cover, please
either ask your local BMW dealer or an experienced
car audio dealer for assistance. In any case follow
the instructions of the car manufacturer.
Please pay attention to the following notes:
1. The cover can be fastened with several hidden
screws to the metal sheet of the car. Make sure
that you have loosened all screws before you try
to remove the cover.
2. Additionally the cover is usually fixed by numer-
ous plastic clips, which may be damaged during
the disassembly when the ambient temperature
is below 10° C. Always pull the cover horizon-
tally to loosen the clips – never apply any vertical
force. Note that broken plastic clips have to be
replaced before reinstalling the cover in order to
avoid undesired rattle and noise.
8
Installation of the UP X4BMW-CTR.3
After you have dismantled the cover of the origi-
nal speaker location, you can remove the original
midrange speaker. Then connect the UP X4BMW-
CTR.3 to the original speaker cable harness and
insert it into the original mounting position.
If the loudspeaker is directly driven by the car radio,
the enclosed inline crossover must be plugged be-
tween the speaker and the original speaker cable
harness.
To speaker To original speaker
cable harness