General Instructions - Audiotec Fischer MATCH UP X4BMW-CTR.3 Bedienungsanleitung

Congratulations!
Dear Customer,
Congratulations on your purchase of this high-
quality MATCH speaker system.
This system highlights best quality, excellent manu-
facturing and state-of-the-art technology.
Thanks to more than 30 years of experiences in
research and development of audio products this
speaker system generation sets new standards.

General instructions

General instructions for MATCH UPGRADE
speaker systems for BMW vehicles
The MATCH UPGRADE UP X4BMW-CTR.3 for
BMW vehicles is a 2-way center speaker system
which will be mounted in the original speaker loca-
tion.
To reach the maximum sound quality, we recom-
mend to use a separate DSP amplifier. In this case
it is mandatory to set a highpass filter with 120 Hz
crossover frequency / 24 dB slope inside the used
DSP amplifier.
General installation instructions for MATCH
components
To prevent damage to the speaker and possible in-
jury, read this manual carefully and follow all instal-
lation instructions. This product has been checked
for proper function prior to shipping and is guaran-
teed against manufacturing defects.
For a proper performance and to ensure full war-
ranty coverage, we strongly recommend to get this
product installed by an authorized MATCH dealer.
We wish you many hours of enjoyment with your
new MATCH speakers.
Yours
AUDIOTEC FISCHER Team
General instruction
speaker systems
The method of installation chosen and level of ex-
ecution will effect the overall performance of the
speaker system. Treat each installation step with a
high degree of attention.
We strongly recommend that you operate the
speaker system at low volume before final installa-
tion. This will allow a trial listening test before secur-
ing the loudspeaker into its mounting location.
Install the cabling in a manner which precludes any
danger of the leads being exposed to shear, crush-
ing or rupture forces. If there are sharp edges in the
vicinity (e.g. holes in the bodywork) all cables must
be cushioned and protected to prevent fraying.
Make sure that all speaker wires easily reach the
speaker terminals without stress on the wire or con-
nectors.
Attention: Ensure that the loudspeaker is correctly
connected (phase), i.e. plus to plus and minus to
minus.
Once you have tested the speaker system and have
confirmed correct operation, turn the audio system
off and prepare the loudspeaker for final mounting.
Further installation guides at
www.audiotec-fischer.com
for installing MATCH
7