Start-Up; Moving And Unpacking - hanseatic HGT85129D Gebrauchsanleitung

Start-up

WARNING
Risk of injury!
The appliance is heavy and bulky.
■
During transport, when setting up
and positioning the appliance, get
help from another person.
Freezer baskets, doors, etc. must not
■
be used as steps or for support pur-
poses.
Health hazard caused by refrigerant!
Do not damage the refrigeration cir-
■
cuit, for example by piercing the re-
frigerant channels of the condensate
vaporiser with sharp objects, cutting
off the tubing, etc.
Refrigerant is fl ammable when spurt-
■
ing out and can damage the eyes. In
this case, rinse your eyes in clean wa-
ter and seek medical assistance im-
mediately.
To prevent the formation of a fl am-
■
mable gas-air mixture in the event
of a leakage in the refrigeration cir-
cuit, the installation space must have
a minimum size of 1 m³ per 8 g of
refrigerant in compliance with the
EN 378 standard. The amount of re-
frigerant contained in your appliance
can be found in the technical specifi -
cations (see page EN-26).
Do not place heat-emitting applianc-
■
es such as microwaves, toasters etc.
on the appliance and do not operate
any electrical appliances inside the
appliance.
Start-up
NOTICE
Risk of damage!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Observe the specifi ed ambient tem-
■
perature (see "Intended use" on page
EN-5).
Improper handling of the appliance
may result in damage.
If possible, do not tip the appliance
■
horizontally, but transport it at a
maximum inclined angle of 45°.
Do not use sharp objects to unpack
■
the appliance.

Moving and unpacking

• Tape the castors under the chest freezer
with adhesive tape to ensure stability dur-
ing transport.
• Transport the chest freezer using a trolley
or with the help of a second person.
• Remove the adhesive strips from the cas-
tors. Lift the chest freezer slightly onto its
left side and push or pull it until it reaches
the desired position.
• Unpack the chest freezer and carefully
remove all packaging, plastic moulding,
adhesive strips and foam padding from
the inside, outside and back of the chest
freezer.
Page EN-19