Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Never immerse electrical appliances, cords or plugs in water or any
other liquid.
•
Do not touch electrical appliances if they have fallen in the water.
Immediately pull the plug out of the socket. Stop using the appliance.
•
Make sure that electrical appliances, cords and plugs do not come
into contact with heat sources, such as a hot hob or open fire.
•
Never let cords hang over the edge of the sink, a worktop or a table.
•
Always remove plug from the socket when you are not using the
electrical appliance.
•
Remove the plug from the socket by pulling the plug itself and not
the cord.
•
Regularly check if the cord of the electrical appliance is not damaged.
Do not use the electrical appliance if the cord shows signs of damage.
If the cord is damaged, it should be replaced by the manufacturer, a
technical service provider or a person with an equivalent qualification,
to avoid any danger.
•
The appliance may not be switched on with the aid of an external
time switch, or by a separate system with remote control.
WHAT YOU SHOULD KNOW ABOUT THIS APPLIANCE
•
Be careful when using the appliance outdoors.
•
Never use the appliance in damp or wet locations.
•
Thoroughly clean the appliance after use (see Cleaning and
Maintenance).
•
Take care that inflammable objects do not get in touch with warm air
of the fan heater.
•
Do not insert objects through the grille.
•
Use the appliance only in a vertical position.
•
Do not place the fan heater directly beneath the wall socket or on
deep ply carpet.
•
When installing, allow for a clearance of 25 cm to the side, 20 cm
above the appliance and 180 cm below the appliance.
28
EN
Werbung
Inhaltsverzeichnis
