Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Blaupunkt 5EG61350 Gebrauchsanleitung

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

Displays
Heat settings
‚ - Š
Residual heat
• / œ
Controls
Main switch
#
Childproof lock
E
Hotplate selection
$

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
ç
When the hotplate is connected: the corresponding indicator lights up. On appliances with multiple zone connection, the display
only lights up when the hotplate has been selected.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: Touch the
#
The indicator light above the main switch and the
light up. The hob is ready for use.
To switch off: Touch the
#
the main switch and the displays go out. All hotplates are
20
Connecting and disconnecting
Select the hotplate and touch the
Select the hotplate and touch the
symbol. An audible signal sounds.
displays
‹
symbol until the display light above
Controls
Adjustment fields
A @
Automatic zone control
ç
Notes
When you touch a symbol, the respective function is
■
activated.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors. The
■
electronics could overheat.
symbol
ç
ç symbol
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to . The display remains lit until the hotplate has
œ
cooled sufficiently.
switched off. The residual heat indicator remains on until the
hotplates have cooled down sufficiently.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 20 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.