Lezyne MINI STVZO E65 Bedienungsanleitung

73158-B1
English User Manual
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws manda�ng ligh�ng vary from country to country. Inform yourself about
ligh�ng laws and regula�ons in the country of use.
Our e-bike lights are powered by the motor of an e-bike and need to be manually installed. Proper installa�on may require some disassembly of the bike and motor (depending on make and
model/ba�ery type) and addi�onal wiring to connect the light to the motor. Please contact the e-bike or motor manufacturer for installa�on instruc�ons. Please note: Any disassembly may
void the warranty of your e-bike. It is highly recommended to have a trained e-bike professional install your lights for you. Below is general informa�on about electrical connec�vity.
MINI STVZO E65
Warnings
The light technical equipment must be safely installed during the en�re usage and must be ensured that the light will not be moved in its posi�on due to uninten�onal adjustment.
DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of another.
Lezyne LED Lights have a water resistance ra�ng of IPX7 under IEC standard 60529. Submerging the device is not recommended. If moisture does enter the casing, air out un�l
completely dry.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
Lezyne USA, Inc. does not accept any liability for injuries or other damages resul�ng from the improper use or improper installa�on of this product in any circumstance.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof of purchase required). Lezyne warran�es cover any
manufacturing defects in materials or workmanship. Issues not covered by warranty include normal wear & tear, improper installa�on, a�emp�ng to access or modify electronics,
damage or failure due to accident, misuse, abuse and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the product.
In the case of an LED not working properly or not working at all do not use your light anymore. These lights must be replaced immediately.
For any warranty ques�ons contact: warranty@lezyne.com
Installation
Lezyne recommends that our E-Bike lights be installed by an E-bike professional.
Below is general informa�on about wiring and moun�ng the light to a compa�ble
bike.
Yellow + Posi�ve
Operation
The front light will be controlled via the on board electronics of the E-bike system. These lights are only to be mounted on E-Bikes with DC voltage that have their own ba�ery charge
indica�on and control. The e-bike system must be capable of automa�cally shu�ng the light off when the onboard ba�ery reaches a cri�cal voltage to avoid deep dischaging of the
ba�ery.
▼Matrix Mini Mount
More Information
For more informa�on on Lezyne products, visit: www.lezyne.com
Black − Nega�ve
Technical Data
Low beam 210 Lumen, 65 LUX
Wa�age 4 W
6-12V AC DC
Input voltage
1 LED
Illuminant
130 cm
Power cable length
Mounting
The light must be mounted in a height between 400 mm and 1200 mm. It must be
ensured that the light technical equipment will not be covered by any parts of the
bike (�re, etc...).
▼Matrix Mini Mount
Between
400 mm
and
1200 mm
Bolt and Washer are not included because of the variety of mounting options.
Motors Compatibility
Bosch (6V) / Bosch (12V)
Shimano E5000, E7000, E6100, E6110, E9000
Shimano E6000, E6001, E6010, E6050
Shimano E8000, E8080, E6002, E6012
Yamaha PWse / Yamaha PW
BionX
Brose Drive T (2018) / Brose Drive S (2018)
Con�nental 48V Prime / Con�nental 48V Revolu�on
Lezyne USA, 645 Tank Farm Rd., Unit F, San Luis Obispo, California 93401
73158-MANUAL FOR Y13 EBIKE MINI STVZO-R0B1