Werbung
1.
OE-No. T10221A toothed wheel pull-off tool for removing the water pump toothed wheel
2.
OE-No. T10222A water pump pull-off tool for removing the water pump
3.
OE-No. T10225 Key for crankshaft T5 for holding or turning the crankshaft while loosening the
gear wheel attachment screw on the water pump. Also required for the TDC adjustment of the
engine shafts
Attention! Keep up the repair of the technical instructions of the manufacturer.
Tool to hold (lock) of the crankshaft, use as OEM T10225.
Remove cover of the pump wheel and loosen
the nut with a special wrench, with tool 3 and
a suitable wrench, you can prevent that crankshaft
twisted when impeller be solved.
Impeller puller, use as OEM T10221A.
Set the puller to the pump gear and pull out pump
by turning the spindle.
Pump puller, use as OEM T10222A
Remove fi xing screws of the pump.
Put the tool 2, turn the 6-point until the puller
touched the engine block, as shown in the picture.
Now the water pump can be pulled out.
4
26028L_manual_75600_de_roh.indd 4
26028L_manual_75600_de_roh.indd 4
07.01.21 09:56
07.01.21 09:56
Werbung
