Installation - Bestron COOL & CLEAN AAC12000 Bedienungsanleitung

INSTALLATION

This air conditioner must be connected to an electrical circuit with a 16 A circuit breaker. It must be kept
away from easily flammable materials and a free space of 30 cm around the device. In addition, a 30 mA
residual current device is recommended. Only use an approved extension cable with a capacity of 16 A.The
air conditioner must be placed on a level surface with sufficient load capacity.
INSTALLATION - Install heat dissipation
1. Choose a location near a window and an
electrical outlet to place the device.
2. Screw the adapter (figure 1-16) onto the drain
hose (figure 1-14) see also figure 2.
3. Mount the drain hose on the warm air outlet (6)
at the back of the appliance (see figure 2).
ATTENTION:
• To avoid damage, the drain hose should not be
deformed or twisted excessively.
• The maximum length of the drain hose is 150
cm. Do not use extensions or other drain hoses
as this can cause serious malfunctions.
• To prevent overheating, do not block the air
outlet on the device.
• If you have a tilt window instead of a sliding
window, purchase a window sealing set to be
able to seal your entire window airtight.
USE - Power on/off
1. Insert the plug in the wall socket. The appliance will beep, this is normal. The displays (Figure 1-A)
indicate the current room temperature.
2. Press the "POWER" button (Figure 1-G). The device will start operating in the last mode used. When
you turn on the device for the first time, it is in cooling mode. The appropriate indicator light above the
button "MODE" comes on.
3. Set the preferred air flow direction. Direct the air flow straight up or slightly forward by setting the
horizontal blinds/shutters (figure 1-3) with the "SWING" button (see figure 1-B), using the supplied
remote control or via the app. Easily rotate or move the unit thanks to the sturdy castors to direct the
airflow into the room.
4. Press the "POWER" button again to switch off the appliance.
5. Remove the plug from the wall socket after use.
USE - Set mode
The device is equipped with three working modes, with which you can ventilate, dehumidify and cool the
room.
Ventilate
1. Press the "MODE" button (Figure 1-F) once or multiple times, until the indicator light "FAN" Lights up.
The device will operate as a ventilator.
2. Press the "FAN" button (Figure 1-C) to switch between low or high speed for the discharged air.
Dehumidify
1. Press the "MODE" button (Figure 1-F) one or more times, until the indicator "DRY" lights up. The device
switches to the lowest speed and will now extract moisture from the air.
44
EN
2