WaterTech POOL BUSTER Gebrauchs- Und Wartungshandbuch Seite 8

HOW TO USE YOUR POOL BUSTER
Your Pool Buster is designed for use in 3 different ways to
vacuum your pool or spa:
A. Vacuum using the handle and the vacuum head removed.
B. Vacuum using the handle and attached vacuum head, with
either wheel or brush attachments depending on pool type.
C. Vacuum using a standard vacuum pole (not supplied) with the
attached vacuum head.
WARNING:
Never use your Pool Buster without the fi lter
bag/seal ring and nose cap properly in place. Doing so will
VOID the warranty.
Using a standard pole
The pole attachment on your Pool Buster is designed to accommodate any
standard pole. To attach a pole, simply press down on the alignment pins
on the pole retaining spring clip. Aligning the holes, slide the pole onto the
Pool Buster and release the clip.
WARNING:
Do not lean on pole or use pole to support weight.
14
Pool Buster Owner's Use & Care Manual
Downloaded from www.Manualslib.com manuals search engine
HOW TO USE YOUR POOL BUSTER
WARNING:
Never put the Pool Buster in water while the charging jack
is connected.
WARNING:
To keep water out of the motor box, before submerging
make sure the On/Off knob is fully secured by turning all the way until it
stops at a 12 o'clock position.
Once your Pool Buster is set-up for use, you may put it in your pool or spa.
• Bring your Pool Buster to the side of the Pool or Spa and turn
it on by turning the On-Off knob all the way to the "On" position.
This can be done outside of the water before it is submerged.
• Once the Pool Buster is "On" it can be completely submerged in
water and is ready for use.
• This appliance is designed to be in water only when in the "ON"
position and has battery power. Excessive leaking can occur
when not running and void the warranty. Never leave your Pool
Buster in the water when it is off.
WARNING:
If any parts are missing, do not operate until the miss-
ing parts are replaced. Failure to do so could result in serious injury.
NOTE: There are two ways to remove the unit from the pool:
1. WHEN USING HANDLE: Lift from pool with the nose facing up
to allow the water to escape from the back and sides.
2. WHEN USING A VACUUM POLE: Remove the unit from the
pool with the bottom facing upwards and the handle facing
down. This will allow the water to escape and keep the dirt
inside
NOTE: The cleaner is only designed to vacuum water and will not vacuum
air. The cleaner will only work when completely submerged in water and
the air is out of the clear funnel.
Pool Buster Owner's Use & Care Manual
15