WaterTech POOL BUSTER Gebrauchs- Und Wartungshandbuch Seite 5

CHARGING YOUR POOL BUSTER
The battery pack for your Pool Buster has been shipped in a low voltage
condition. It should be charged overnight prior to use.
WARNING:
The Pool Buster charger is for indoor use only.
NOTE: Batteries will not reach full charge the fi rst time they are charged.
Allow several cycles for them to fully charge. Allow the batteries to cool
after initial use.
WARNING:
Do not expose charger to excessive moisture or extreme
heat or cold. Charge battery only with the battery charger provided.
PRECAUTIONS:
Make sure power supply is normal household volt-
•
age, 120 volts, 60 Hz, AC only.
Do not handle Pool Buster while charging with wet
•
hands or without shoes.
Do not use or store your charger outdoors. Charge
•
battery indoors in a clean dry place. For best results, your
Pool Buster battery should be charged in a location where the
temperature is above 50 degrees F and below 100 degrees F.
• Only use the charger supplied to recharge this vacuum. Do not
use the supplied charger with any other appliance or damage
may occur.
• Disconnect Pool Buster from power charger when not in use.
• Unplug the charger from outlet before any routine cleaning or
maintenance.
• The use of extension cords is not recommended. Plug the
charger into a properly grounded standard electrical outlet
(120v/60Hz) only.
• To protect against risk of electrical shock, do not put unit char-
ger in water or other liquid.
• To avoid damage to the charger and cord, never carry the char-
8
Pool Buster Owner's Use & Care Manual
Downloaded from www.Manualslib.com manuals search engine
CHARGING YOUR POOL BUSTER
ger by the cord or yank to disconnect from an outlet. Instead,
fi rmly grasp the charger body and pull to disconnect. Do not
pull cord around sharp edges or corners.
• Do not allow the cord to hang over the edge of a table or
counter or touch hot surfaces. The vacuum should be placed or
mounted away from such hot surfaces.
TO CHARGE
• Turn the knob counterclockwise to remove the On-Off Knob.
This will expose the charging jack connection. NOTE: When
removing the On-Off knob it is normal to hear air escaping. The
air inside has simply expanded from being heated by the motor.
• Connect the lead from the charger to the charging jack on the
Pool Buster.
• Connect the charger to the appropriate electrical outlet.
• After charging, ensure that the On-Off knob is fully secure and
turned to the "Off" position before attempting to use your Pool
!Caution:
Buster. Replace On-Off knob after charging. Plac-
ing Pool Buster in water without replacing the knob will void your
warranty.
Pool Buster Owner's Use & Care Manual
9