Making A Phone Call - Siemens PTT Bluetooth Bedienungsanleitung

Switching the Bluetooth
headset on and off
Hold down the on/off button for
between 2 and 5 seconds. The
headset is now switched on. The
LED will flash.
To switch off the headset, hold
down the on/off button again.
The headset switches off
automatically if it is not used for more
than 10 hours.
Resetting the headset
To register the Bluetooth™
headset with another mobile
phone, you must reset the
headset to the factory settings:
1. Switch off the headset (see
above).
2. On the headset, hold down
the on/off button and the
key for at least 5 seconds. The
LED will flash rapidly 5x.
The headset has now been reset
to the factory settings. You can
now register the headset with
another mobile phone (p. 6).
Downloaded from www.Manualslib.com
Headset PTT Bluetooth™ (en)
manuals search engine

Making a phone call

To make a telephone call, the
headset must be switched on
(see left) and there must be a
link to the mobile phone (p. 6).
The procedure described below
only applies to Siemens mobile
phones. It may be different for
other manufacturers' mobiles.
The following symbols are used
to explain operation:
L
This function is service-pro-
vider-dependent, you may
need to register separately
for this service.
• You will know the call is about to
drop if the signal quality is poor.
• If you move out of the Bluetooth™
range of the mobile phone, the
Bluetooth™ link will be interrupted.
Ò
To continue the call you must press
the PTT key within 5 seconds.
• If the mobile phone no longer has a
connection to the network, you will
hear a repeating beeping sound.
7