Siemens PTT Bluetooth Bedienungsanleitung Seite 7

6
The Travel Charger and Car
Charger are available from the
range of original Siemens
accessories.
1. Insert the charging adapter
in the headset
2. Insert the charging unit
connector
charging adapter as shown.
3. Plug the charging unit into the
wall socket. Please read the
notes on the charging unit in
the relevant manual.
Charge time
A flat battery takes about two
and a half hours to fully charge.
Display during charging
The headset switches off
automatically when it is
connected to a charging unit.
The LED is red during charging.
When the battery is fully
charged, the LED is green.
Downloaded from www.Manualslib.com
Headset PTT Bluetooth™ (en)
.
into the
manuals search engine
Registering the headset with
the mobile phone.
The headset must be switched
off.
1. Hold down the on/off button
for at least 5 seconds. The LED
is now illuminated and your
mobile phone can now
"search" for the Bluetooth™
headset.
2. Activate search mode on your
mobile phone. Please read the
notes in your mobile phone
manual.
3. When the mobile phone finds
your headset, this will be
shown on your display with
the device name
HHB-505.
If your mobile phone does not find the
headset within 3 minutes, the phone
switches off. To reactivate search
mode, hold down the on/off button for
a further 5 seconds.
4. If requested, enter the
password (PIN) for the
headset into your mobile
phone:
0000.
The Bluetooth™ headset is now
registered with the mobile
phone.