Locking With A Key; Battery Warning - Stûv TULOX 100 Benutzerhandbuch

Depending on the type of mounting, the cable has been run through the axis (see image on page 29) or
through a separate drilled hole.
If the cable has been run through the axis, then you will have to pull the cable out with a start.
Only then will you be able to lay the keypad to the side. Remove the axis from the keyhole. Now
the keyhole is free and you can open the lock using the key. Before the lock can be opened again
by entering a code, the cable has to be replaced and assembled properly. Call a service technician
to do this.
If the cable has been run through a separate drill hole, then you will only have to pull the axis
through the key hole. Now the keyhole is free and you can open the lock using the key. Before the
lock can be opened again by entering a code, the axis and the keypad have to be replaced and
assembled properly.
Opening with a Key
Insert the key all the way into the lock. The lock is opened by turning the key ca. 170° in a clockwise direc-
tion. The key is used to move the lock only.
When using the key to pull the door open, please be aware that the key can only take on a limited amount
of force. Applying too much force can cause damage to the lock and the key.

Locking with a Key

Locking is done in the opposite procedure as opening.

Battery Warning

If the batteries reach a critically low level of charge, there will be an
early warning of several signal tones after opening.
Replace the batteries (4x, 1.5V, alkaline, AA, mignon, LR6).
- 30 -
User Manual TULOX 100
Steinbach & Vollmann GmbH & Co. KG • 42579 Heiligenhaus
nnnnnn
after opening