Clearing Data From Memory; Backlighting The Display; Measurements; Single Distance Measurement - RIDGID micro LM-100 Bedienungsanleitung

ments or calculated results, shown in reverse order. Use the Addi-
tion or Subtraction Buttons

Clearing Data From Memory

Press and Hold the Memory Button
Clear/Power Button Key
memory.

Backlighting the Display

Press the Backlight/Unit Change Button
light ON or OFF.

Measurements

The RIDGID micro LM-100 Laser Distance Meter has a measuring
range of 100 m (328') maximum. Use in bright sunlight may de-
crease the range of the meter. The reflective properties of the sur-
face may also decrease the range of the meter.
Measurement errors can occur when measuring to clear, semi-per-
meable or high gloss/reflective surfaces such as colorless liquids
(e.g. water), glass, Styrofoam, mirrors, etc. Applying a commercially
available laser target plate to the surface may allow more accurate
measurements.
NOTI E Do not aim the laser at the sun. This can damage the
meter.

Single Distance Measurement

1. Press ON/Measurement Button
ON/Measurement Button
2. The measured value is displayed immediately.
999-998-391.09_REV. D
to move through these records.
and Press and Hold the
at the same time to clear all data in the
to turn the display back-
to activate the laser. Press
again to take a measurement.
micro LM-100 Laser Distance Meter
Continuous Measurement, Max and Min
Measurement
1. Press and Hold Continuous Measurement Button
the continuous measurement mode. In continuous measure-
ment mode, the measured value is updated approximately
every 0.5 seconds in the third line. The corresponding minimum
and maximum values are displayed dynamically in the first and
second line.
2. Press and Hold either ON/Measurement Button
Power OFF Button
ments. The device automatically stops after 100 continuous
measurements.

Adding/Subtracting Measurements

1. Press Addition Button
previous one.
2. Press Subtraction Button
the previous one.
3. Press Clear/Power OFF Button
4. Press Clear/Power OFF Button
single measurements.

Area Measurement

1. Press Area/Volume Button
display. The distance to be measured will flash in the symbol.
2. Press ON/Measurement Button
ment (e.g. length).
3. Press ON/Measurement Button
measurement (e.g. width).
4. The result of the area calculation is displayed in the third line; the
individually measured values are displayed in lines 1 and 2.
to stop taking continuous measure-
to add the next measurement to the
to subtract the next measurement
to cancel the last action.
again to return to taking
. The symbol appears in the
to take the first measure-
again to take the second
to enter
or Clear/ -
9