English; Care Instructions - IKEA SILVERGLANS Typ ICPSHC24-30-IL44-1 Bedienungsanleitung

English

HOW TO STEER YOUR LIGHTING
When the driver is connected to the mains, it is
possible to turn ON/OFF all products connected to
the driver, but if you want to dim or connect your
products to IKEA Smart lighting products, you need
to buy a separate steering device (e.g. a remote
control).
The steering device needs to be paired with your
driver/s. If you have more than one (1) driver you
can pair each one with the steering device, so that
the entire combination can be turned ON/OFF or
dimmed at the same time.
PAIRING A STEERING DEVICE TO YOUR DRIVER
1. Connect at least one (1) product to the driver
before you begin the pairing. Make sure that the
mains power is turned ON.
2. Locate the pairing symbol on the driver. Hold the
steering device close to the pairing symbol
(no more than 5 cm away).
3. Press and hold the pairing button on the
steering device for at least 10 seconds. A red
light will shine steadily on the steering device.
The product connected to the driver will begin to
dim and flash one time to indicate that the driver
is being paired to the steering device.
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to
un-pair the driver from a steering device you might
have to make a factory reset. The driver is forced to
factory reset by carefully push and hold the small
button (marked RESET) with a tip of pen on the
driver enclosure and applying a slight pressure. A
factory reset can also be done by toggle the main
switch 6 times.
IMPORTANT!
• The driver is for indoor use only and can be used
in temperatures ranging from 5ºC to 45 ºC.
• Do not leave the driver in direct sunlight or near
any heat source, as it may overheat.
• The declared radio range between the driver
and the steering device is measured in open air.
Different building materials and placement of the
units can affect the wireless connectivity range.

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical solvents
as this can damage the product.
PRODUCT SERVICING
Do not attempt to repair this product yourself, as
opening or removing covers may expose you to
dangerous voltage points or other risks.
TECHNICAL DATA
Type: ICPSHC24-30-IL44-1
Input: 220-240 VAC, 50/60 Hz, 0.23A
Output: 24.0V DC
Max total load: 1.24 A, 30.0 W
Radio range: 10 m in open air.
Operating frequency: 2405-2480MHz
Output power: 14 dBm
IP-class: IP44
Average active efficiency: 88.1 %
Efficiency at low load (10 %): 75.6 %
No load power consumption: 0.28 W
Indoor use only
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
Declaration of Conformity
Hereby, IKEA of Sweden AB declares that the
radio equipment type ICPSHC24-30-IL44-1 is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity can
be found at http://www.ikea.com
– Choose the country you are in
– Search your product in the search field
– Go to Assembly Instructions and Manuals
(downloads) Here will you find a pdf file of the
full DoC.
The crossed-out wheeled bin symbol indicates that
the item should be disposed of separately from
household waste. The item should be handed in for
recycling in accordance with local environmental
regulations for waste disposal. By separating a
marked item from household waste, you will help
reduce the volume of waste sent to incinerators
or land-fill and minimize any potential negative
impact on human health and the environment. For
more information, please contact your IKEA store.
4