Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Calibration button
5
Stellen Sie nun den korrekten Abstand zwischen
Düse und Druckbett ein.
Dies können Sie mit Hilfe eines Blatt Papiers oder
einer Fühlerlehre vornehmen.
Zurück
Weiter
• Slide the paper back and forth
between the nozzle and BuildMat, if
the paper can't be moved, the user can
clockwise rotate the screw with the
Allen Key until there is slight resistance
between the nozzle and the paper.
If the paper can be slided easily
between the nozzle and BuildMat. The
user can anticlockwise rotate the
screw with the Allen Key until there is
slight resistance between the nozzle
and the paper.
Installing the filament
1
• Mount the filament on the spool
holder.
3
• Press the release arm and insert the
filament down to the extruder
connector.
Filament feed
1
System
Werkzeuge
Drucken
• Enter into "Tool"->"Filament".
3
Temperatur
E1
26/0
℃
E1
Extruder
Entladen
Laden
Stop
Zurück
• Press "Temperature" to preheat.
• In the <Filament> menu, adjust the
temperature to 210 ºC and wait until
the actual temperature has reached
the target temperature.
• Press <Load>.
6
②
①
③
④
• Repeat STEP 5 for the second, third,
and fourth point (calibration sequence
and motion direction of the nozzle are
shown).
2
• Cut the filament with an angle
2
Drucktisch
Position
Temperatur
Filament
Lüfter
Stop
Ton
Zurück
4
Temperatur
E1
210/210
℃
E1
Entladen
Laden
Extruder
Stop
Zurück
5
Temperatur
E1
208/208
℃
E1
Laden
Entladen
Extruder
Stop
Zurück
• If filament comes out of the nozzle, press <Stop>. Remove the filament remnants
with a pair of tweezers.
Starting the printing process
1
System
Werkzeuge
Drucken
3
80mmSmallRod.gcode
• Enter into Print and select the file to start printing.
5
7
• When the printing is finished, the user can take out the flexible BuildMat and remove
the prints with their hand, no any tools needed. Now the user get what they want so
easily.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights reserved, including translation.Reproduction by any method, i.e.photocopy, microfilm, or in digital, electronic,
optical or in any form, requires prior written approval from the publisher. Reproduction by printing, even in part, is also
prohibited. This publication represents the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE.
2
→System Volume Information/
Body-MINI.gcode
Body-MINI+.gcode
→1/
4
1
2
24/50
24/0
---/---
00h00m
--h--m
0
mm/s
80mmSmallRod.gcode
1%
6
*2226740_v1_0920_02_mxs_qsg_en
Werbung
