Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quick guide
Basic 3 3D printer fully-assembled
Item no. 2226740 Basic 3
Delivery content
3D printer fully-assembled
Adaptor and AC cable
Flexible magnetic BuildMat
Allen Key within 2.5mm dia.
Small needle 0.3*75mm
Detailed Operating Manuals
A detailed operating manual can be downloaded from
www.conrad.com/downloads or you can scan the QR code on this page.
Follow the instructions on the website.
Product picture
Features
• Max. size of the printed object120 × 120 × 180 mm
• Print various materials PLA, PLA compound
• Printed layer thickness 0.05 mm - 0.3 mm
• Print speed 20 mm/s - 100 mm/s
• Nozzle size 0.4 mm (included) 0.2/0.3 mm optional
• Colour touch screen display
• Operating voltage: 100 - 240 V~
• Connectivity microSD card
• Slicing software cura
Card reader
filament tube
microSD card
Ejector Rod
Spool holder
Setting up the equipment
1
• Remove the PE foam.
3
• Install the spool holder at the right side
of the 3D printer
4
• Insert one end of the filament tube into the feed port and the other end into the
extruder connector.
Print bed calibration
• printer is well calibrated when out of the factory. But there will be the deviation
during the transportation, it is better to do the slight calibration before start printing.
1
System
Werkzeuge
Drucken
• Click on the menu "Tool".
3
• Place an 1/4 A4 sheet of the paper between the nozzle and the print bed to use as
a measurement guide.
2
• Plug the power cable, turn on the
device, go to menu "Tool", click on
"Manual", press "Z+" to lift up the Z
axis and remove the PE foam.
5
2
Drucktisch
Position
Temperatur
Filament
Lüfter
Stop
Ton
Zurück
• Click on the menu "Level".
4
Werbung
