Adjusting Volume - Lupilu 321411 1901 Gebrauchsanweisung

Close the product the same way. Be sure to re-
move the item used before you give the product
to your child.
Note: Remove the plastic tongue (1e) from the
battery compartment lid (1d) before first use.
2. Slide the switch (1f) to ON to switch it on, or
to OFF to switch it off.
Features
1. Slide the switch (1f) to ON in order to switch
the product on (fig. C).
2. Press on the button (1b) to switch features on
or off.
Note: When you switch the features on, the
melody is at highest volume and the light is in
alternating mode.
Note: When not in use the features switch off
automatically after about 45 minutes.
Switching soothing melody on and
off
When the features are switched on, the soothing
melody is automatically switched on.
• Press the button (1a) twice to switch the sooth-
ing melody off.
• Press the button again to switch the melody
on.
• Press the button (1a) once to set the volume at
low level.
Note: The melody is played back at the highest
volume when you switch the features on and
it switches off automatically after about 45
minutes.
Note: The product plays 15 melodies automati-
cally in a continuous loop.

Adjusting volume

The product has three volume modes.
• Press the button (1a) to regulate the volume.
Note: When you switch on the features, it is set
at the highest volume.
• Press the button down until you have reached
the desired volume level.
When regulating the volume the sequence is as
follows:
High - Low - Off
Switching light projection on and off
The product has four colour modes for the light
projection.
• Press the button (1c) repeatedly until you have
reached the desired light projection.
Note: When you switch on the light projection
the sequence is as follows:
Alternating - Green - Red - Blue - Off
Note: The light projection switches off automati-
cally after approx. 45 minutes.
Replacing batteries (fig. D)
WARNING! Follow these instructions to
avoid mechanical and electrical dam-
age.
The product comes with three batteries.
If the batteries no longer work, replace them as
follows:
1. Open the zip on the bottom of the product.
2. Switch the product off by sliding the switch
(1f) to OFF.
Note: For safety reasons the zip does not
have a slider so that children cannot open the
product.
Use a paper clip or some other item of everyday
use to open. Attach the item used to the eyelet in
the zip and pull on it.
Close the product the same way. Be sure to re-
move the item used before you give the product
to your child.
3. Using a suitable screwdriver loosen the screw
on the lid of the battery compartment (1d)
and remove it.
4. Take out the batteries inside the product.
5. Carefully insert the new batteries into the
battery compartment (1g). The batteries must
be fully seated in the battery compartment.
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
6. Screw the battery compartment lid (1d) back
on tight and close the zip.
GB/IE 9