Safety Feature; Electromagnetic Fields (Emf); Preparing For Use - Philips HR1871 Bedienungsanleitung

caution
- This appliance is intended for household use only.
- Do not hold the appliance by the locking arm when you carry it.
- Never use any accessories or parts from other manufacturers or that Philips does
not specifically recommend. If you use such accessories or parts, your guarantee
becomes invalid.
- Make sure all parts are correctly assembled before you switch on the appliance.
- Only use the appliance when the locking arm is in locked position.
- Only lower the locking arm to unlocked position after you have switched off the appliance and
the filter has stopped rotating.
- Do not operate the juicer for more than 40 seconds at a time when you juice heavy loads and
let it cool down sufficiently afterwards. None of the recipes in this user manual constitute
heavy loads.
- Always unplug the appliance after use.

safety feature

- This juicer is fitted with a safety feature which safeguards against overheating due to excessive
loads. In case of overheating, the juicer automatically activates the overload protection and
switches itself off. If this occurs, set the control knob to 0, unplug the appliance and allow it to
cool down for 15 minutes. Remove the juice jug and detach the lid, juice collector and the
integrated pulp container and then press the overload protection button on the bottom of the
motor unit (Fig. 2).

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

Preparing for use

1 Make sure all detachable parts are clean (see chapter 'Cleaning') and assembled correctly.
2 Unwind the mains cord from the base of the motor unit (Fig. 3).
3 Assemble the integrated pulp container onto motor unit (Fig. 4).
4 Assemble the juice collector onto the integrated pulp container (Fig. 5).
5 Assemble the filter onto the driving shaft of the motor unit. Make sure the filter is fitted
securely onto the driving shaft ('click') (Fig. 6).
6 Assemble the lid onto the juicer (Fig. 7).
7 Lift the locking arm to locked position ('click') (Fig. 8).
8 Place the lid on the juice jug to avoid spattering (Fig. 9).
Note: The integrated foam separator ensures clear juice as an end result.
9 Place the juice jug under the spout (Fig. 10).
Note: If you want to extract juice straight into a glass, use the spout accessory (Fig. 11).
10 Turn the spout to the flow position before you start juicing (Fig. 12).
All manuals and user guides at all-guides.com
EnglisH
7