Faults And Remedies - Schäfer smartDRAFT Gebrauchsanweisung

8.

Faults and remedies

Type of fault
smartDRAFT Dispense
Head does not fi t on the
smartDRAFT KEG
smartDRAFT TAP is not
working
too much foam
drink is too warm
compressor does not work compressor is not switched on
cooling fi ns in the
smartDRAFT Cooler are not properly closed
covered in ice
18
Downloaded from www.Manualslib.com
Possible causes
the front part of the smartDRAFT Dis-
pense head does not lie in the cut-out
in the top ring of the smartDRAFT KEG of the top ring
the smartDRAFT Dispense Head
was not attached completely withdraw
smartDRAFT TAP is not attached
properly
smartDRAFT KEG has not been
pre-cooled
dispensing temp. not yet reached
door of smartDRAFT Cooler are
not properly closed
smartDRAFT KEG has not been
pre-cooled
cooling fan motor dirty or defective
ventilation grille is covered
unit placed too close to a wall
refrigeration circuit leaks or the
compressor is defective
or is defective
door of smartDRAFT Cooler are
smartDRAFT Cooler has been
operated without a KEG
manuals search engine
Remedy
attach the smartDRAFT Dispense Head
so that the front part fi ts in the cut-out
completely withdrawn the smartDRAFT
Dispense Head and attach it on the KEG
please refer to instruction on
page 9
pre-cool smartDRAFT KEG and
pay attention to LED display
and wait until the KEG has reached
8°C.
wait until LED Display has reached
8°C
close door until you hear locking
clip click into place
pre-cool smartDRAFT KEG and,
inform service technician
uncover grille
ensure suffi cient distance
inform service technician
inform service technician
remove the plug from the power
supply, allow the fi ns to defrost.
Mop up any moisture with a soft
cloth. Always close the door
remove the plug from the power
supply, allow the fi ns to defrost.
Mop up any moisture with a soft
cloth. smartDRAFT Cooler
may only be operated with a
smartDRAFT KEG