Using The Winemaster Sp100; Connecting The Air-Conditioner; Control Panel - WINEMASTER Wine SP 100 Installationsanleitung Und Bedienungsanleitung

USING THE WINEMASTER SP100

5
The Winemaster SP100 must be installed by complying with the national rules of electric
installation
5.1

CONNECTING THE AIR-CONDITIONER

Connect the male plug to a 230/16A power socket. Switch on the air-conditioner by pressing the green button on
the back of the inside unit..
The fan on the cellar side comes on immediately.
The compressor may not come on until 2 minutes later if the temperature in the cellar is higher than the set
temperature. If the cellar temperature matches the thermostat setting, the compressor will not come on.
5.2

CONTROL PANEL

The setting of the targeted temperature is made on the thermostat :
Explanations of the main display symbols:
Red light = cold mode engaged (compressor working)
Red light = Not used
Red light = defrost
Red light = heat mode engaged (resistance)
- Press button
- Use button to increase the temperature
- Use button
- When the right temperature is set, press again on button
confirm it.
one second until the targeted temperature is blinking.
to lower the temperature.
to
12