Behringer WING-DANTE Quickstart Seite 14

14
WING-DANTE Quick Start Guide
*
Warning
Failure to observe the following warnings may lead to fatality or
serious injury from fire or electric shock.
Before installing the card, you must refer to behringer.com to verify
that your host device supports this card, and to verify the number of
cards that can be installed in combination with other Behringer or
third-party cards.
• •
Do not attempt to disassemble or modify the card. Do not apply
excessive force to board connectors or other board components.
Mishandling of board may lead to shock, fire hazard, or
equipment failure.
• •
Disconnect the power cable from the main unit before installing
this card to eliminate shock hazard.
*
Caution
Failure to observe the following precautions may lead to personal
injury or may result in damage to equipment or other property.
• •
Do not touch the board's metallic leads (pins) when handling the
card. Pins are sharp and may cause injury.
• •
The card is electrostatic-sensitive. Before handling the
card, you should briefly touch the main unit's metal
casing with your bare hand so as to drain off any static
charge from your body. Behringer assumes no responsibility
for data loss, equipment damage, or injury caused by
inappropriate handling or usage.
FCC INFORMATION U.S.A.
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product,
when installed as indicated in the instructions contained in this
manual, meets FCC requirements. Modifications not expressly
approved by Behringer may void your authority, granted by the FCC, to
use the product.
2. IMPORTANT: When connecting this product to accessories and/
or another product, use only high-quality shielded cables. Cables
supplied with this product MUST be used. Follow all installation
instructions. Failure to follow instructions could void your FCC
authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the
requirements listed in FCC Regulations, Part 15 for Class "B" digital
devices. Compliance with these requirements provides a reasonable
level of assurance that your use of this product in a residential
environment will not result in harmful interference with other
electronic devices. This equipment generates/uses radio frequencies
and, if not installed and used according to the instructions found in
the documentation, may cause interference harmful to the operation
of other electronic devices. Compliance with FCC regulations does
not guarantee that interference will not occur in all installations. If
this product is found to be the source of interference, which can be
determined by turning the unit "OFF" and "ON", please try to eliminate
the problem by using one of the following measures: Relocate either
this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch circuits (circuit
breaker or fuse) or install AC line filters. In the case of radio or TV
interference, relocate/reorient the antenna. If the antenna uses
300 Ohm ribbon cable, use coaxial cable instead. If these corrective
measures do not produce satisfactory results, please contact the local
retailer authorized to distribute this type of product. If you cannot
locate the appropriate retailer, please contact Behringer customer
service.