Nowsonic TITAN 520 Bedienungsanleitung Seite 6

www.nowsonic.com
Parallel Mode
When using the Parallel Mode, the amplifier is configured to use the
input on channel 1 only. Individual output levels for left and right can
be controlled on the front panel.
The Mode button should be in "PARALLEL" position.
Connect signal source to channel 1 only using the channel 1's XLR,
¼-inch or RCA connectors.
Downloaded from www.Manualslib.com manuals search engine
Bridge Mode
Bridge Mode delivers the power of both amp channels into a signal
8 ohm load.
The Mode button should be in "BRIDGE" position.
Connect signal source to channel 1 only using the channel 1's XLR,
¼-inch or RCA connectors.
Connect the speaker as shown.
a) If using the Binding Post output, connect the positive terminal of
the speaker to the positive terminal of channel 1 and the negative
terminal of speaker to the negative terminal of channel 2.
b) If using a Speakon connector, connect the positive terminal of the
speaker to 1+ and the negative terminal to 2-. Plug the connector
into the channel 1 output only.
7
TITAN 520
EN
User manual