Before Using - mamibot iGlassbot W110-F Gebrauchsanleitung

Before Using

• W110-F should always connect to power cable for normal use.
• How to put W110-F onto glass to start using?
1). Connecting the W110-F with the power supply, then turn the switch on, make
sure the fan is running.
2). Put W110-F onto the glass, make sure it keeps 10cm away from the window frame.
3). Make sure W110-F can stick on the glass before releasing it.
• How to take W110-F down from glass?
1). While W110-F is running, please hold safety rope with one hand and take W110-F
down from glass with the other hand.
2). Turn off power switch in safe area.
• Safety rope and buckle
1). Before using, check if the safety rope is broken or the knot is loose.
2). Fasten the safety rope and tie to indoor fixture before next step.
• UPS(Un-interrupted Power System) function
1). The UPS function will be enabled automatically when no electric power supplied
The backup time of this UPS is 20-30 minutes.
2). If no electric power is supplied, W110-F will stop automatically, alert and red
flashing. User shall take W110-F down from the glass as soon as possible.
3). User can pull W110-F back by pulliing safety rope. Slightly pull the safety rope at
an angle close to the glass to prevent dropping.
• Please make sure the battery was full-charged(Green Indicator On) before use.
1). Turn off the power switch on W110-F, plug in the power supply. If the indicator is
orange, it means charging.
2). If the indicator is green, it means fully charged.
• Table cleaning mode
Put W110-F on the table and select auto-cleaning mode, the device will run in
table-cleaning mode.
※Notice
1). Do not use it on frameless glass.
2). Make sure put cleaning ring onto cleaning wheel correctly for no leakage.
3). Do not sue it in rainly or moist day.
4). Set danger-warning area downstairs for no-balcony window and door.
5). Do not add dirty water and corrosive liquids into the water tank.
How to Clean the Glass
Step 1: Add clean water/detergent liquids/glass water into the water tank.
Step 2: Use only the original clean and dry cleaning cloth to clean dust and sand on
the glass.
Step 3: Change the cleaning cloth according to the usage. Spray some water or
detergent liquids to make cloth wet via remote control or APP.
※Notice
1). Please choose the suitable spray interval according to the usage, if the glass is too
wet or too dry,W110-F can not move well.
2). It is prohibited to add solid cleaner into the water tank.
6