Troubleshooting - V-TAC VT-2002WRD Handbuch

ENGLISH

TROUBLESHOOTING

REMOTE CONTROL IS NOT WORKING:
1. Ensure the distance between the remote control and device is maximum 6 meters
2. Ensure the batteries are installed correctly and charged.
3. If batteries are discharged please charge or install new batteries.
HEATER IS NOT WORKING:
1. Ensure the plug is connected to the power and is switched ON.
2. Ensure the side switch of the heater is powered ON. (Set the switch (Point E) to ON position (Refer Figure 1
and Table 1)
3. Turn OFF the power and inspect there are no damages to the power cord and plug.
4. Check if the heater is in standby mode. If yes then set the desired mode temperature to start using the heater.
NOTE: If any part of the heater needs to be replaced please ensure it is only replaced by qualified person only.
14