Jam TRAVEL ANC HX-HP110 Gebrauchsanleitung Seite 3

SET UP
CHARGING YOUR HEADPHONES
The "JAM Travel ANC" headphones are powered by a
rechargeable battery. The headphones come
pre-charged; however, for optimal play time, be sure
to charge before first use.
A – Unwrap the charging cable and plug the micro
USB end into the charging port on the headphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for
your cell phone or pick one up next time you're at
the store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 24 hours of
playtime (with Bluetooth
playtime with ANC and Bluetooth
the light will stay solid red. Once fully charged, the
LED will turn off.
USE
A – TURN ON YOUR HEADPHONES
Press and hold the power button for 2 seconds to
turn on your headphones.
B – CONNECTING TO A DEVICE
Once turned on, the headphones will immediately
search for a device to pair to; the LED will blink red
and blue alternately. Enable Bluetooth
device. From the Bluetooth
ANC." Once it's connected, you will hear a tone and
the LED light will flash blue every 5 seconds.
Once paired, your device and headphones will find
each other every time, as long as your device's
Bluetooth is on. If you're connecting to a computer,
®
you may have a few more steps on that end.
You'll have to get that information from the
computer company.
Holding down the "+" and "–" buttons at the same
time, for 3 seconds, will disconnect a paired device.
Once disconnected, the Travel ANC will need to be
repaired.
EN
only) or up to 18 hours of
®
. While charging,
®
on your
®
menu, select "JAM Travel
®
Travel
ANC
You may also connect your device to the headphones
using the included aux cord.
+
2 hrs 18 hrs 24 hrs
...2s
JAM Travel ANC
...1x
3