Cleaning And Maintenance - aprilla AHC 5007 Bedienungsanleitung

USE
• The following table provides which comb you need to cut the desired lengths.
• To put the comb down, hold the comb with teeth up and push the comb firmly against the
blade side.
Comb 1 leaves hair approx. 0.3 cm. in length.
Comb 2 leaves hair approx. 0.6 cm. in length.
Comb 3 leaves hair approx. 0.9 cm. in length.
Comb 4 leaves hair approx. 1.2 cm. in length.
• At the beginning, cut only a small amount of hair until you become accustomed to the length.
Each comb leaves the hair. It is suggested to try the longest comb 4 on the clipper first, then
use a another comb if the desired length is shorter. For uniform cutting, never push or force
the clipper through the hair at a fast rate.
• Start by combing the hair in its natural direction, place the largest, attachment comb onto
the clipper and start by trimming the sides from the bottom upwards. Hold the clipper lightly
against the hair with teeth of the attachment comb pointing up.
• Slowly lift the clipper up and outward through the hair, cutting only a small amount at a time.
Repeat around sides and back of head.
Use blade lever
• The allows you to gradually change the closeness of your cut without an attachment comb.
When the lever is in the uppermost position, the blades will give you the closest cut and leave
the hair very short. Pushing the lever downward gradually increases the cutting length.In its
lowest position, the lever will leave the hair approximately the same
• Always remove the plug from the outlet first. After each use, remove any hair with the cleaning
brush and spread one or two drops of oil on the blades. Use only acid-free oil as supplied.
Unscrew the blades regularly and remove all hair trimmings. When replacing the blades make
sure that they are properly adjusted. The blades are adjusted as follows:
• Screw the blades back on the clippers, but do not turn the screws tightly yet.
• Turn the blade lever to the side downward.
• Shift the top blade until it is even (parallel) with the bottom blade and be sure that the two
blades are about 1.2mm (1/32 inch) apart.
• Now tighten screws firmly and make sure that the blades cannot shift.
• Clean the outside of the clipper with a clean soft, damp cloth. Never immerce the device in
water or other liquid.Do not place or store appliance where it can fall or be pulled into a tub
or sink.

CLEANING AND MAINTENANCE

• Brush the blades using the cleaning brush to remove any hair.
• After each use it's recommended to oil the trimmer blades with the supplied oil.
GUIDELINES FOR PROTECTION OF THE ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its durability,
but must be offered at a central point for the recycling of electric and electronic
domestic appliances. This symbol on the appliance, instruction manual and packaging
puts your attention to this important issue. The materials used in this appliance can
be recycled. By recycling of used domestic appliances you contribute an important
push to the protection of our environment. Ask your local authorities for information
regarding the point of recollection.
AHC 5007 instruction manual
3