Running-In Period; Fork Lifting And Lowering; Move Forward /Reverse - HOLZMANN-MASCHINEN HUB15FLEX_24V Betriebsanleitung

16.2 Running-in Period

The machine has a running-in phase of 100h. Please keep the following things in mind:
• Please charge the battery at a charge capacity of 30%, never use machine with a lower
battery capacity.
• Do not brake or turn abruptly.
• Maximum load should be limited to 80% of the maximum capacity.
• The Hydraulic oil should be changed after max. 100h.

16.3 Fork lifting and lowering

Lifting the fork:
Push the lever into the lifing position (lever all
the way down) and use the tiller arm to pump
the fork to the desired height.
Lifting the fork:
Press the upper button to lift the fork as long
as the button is pressed, the fork is moving
upwards.

16.4 Move forward /reverse

When moving the machine, please select the lowest possible fork position.
Forward/Reverse:
To drive forwards (V) turn the selector switch forwards, to drive backwards (R) turn it in the opposite direction. The
greater the angle of rotation, the higher the achievable driving speed.
R
V
To set the machine in motion, pull the drawbar into the swivelling range M.
The travel distance can be changed by swivelling the drawbar to the right or left.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Hub15Move_24V
Lowering the fork:
Push the lever to the lower position (lever all
the way up). To return to the lowest fork
position, move the lever to the position in the
middle (shown in th picture)
Hub15Flex_24V
Lowering the forks
Press the bottom button to lower the fork as
long as the button is pressed, the fork is
moving downwards
Lifting button
V O R S I C H T
Hub15Move_24V
Hub15Flex_24V
OPERATION
Lowering button
22
HUB15FLEX_24V; HUB15MOVE_24V