English - Kenwood CG100 Bedienungsanleitung

Downloaded from www.Manualslib.com
before using your Kenwood
appliance
G
Read these instructions carefully and
retain for future reference.
G
Remove all packaging and any
labels.
safety
G Never use a damaged appliance.
Get it checked or repaired: see
'service'.
Never put the appliance in water or
G
let the cord or plug get wet – you
could get an electric shock.
G Unplug;
G G before cleaning
G G after use
G Avoid contact with moving parts.
G The motor should not be allowed to
run for longer than 1 minute in any 5
minute period.
G
Do not let the cord hang over the
edge of the worksurface or touch
hot surfaces.
G
Do not let infirm people use the
appliance without supervision.
G
Do not let children use or play with
the appliance.
G
Only use the appliance for its intend-
ed domestic use. Kenwood will not
accept any liability if the appliance is
subject to improper use, or failure to
comply with these instructions.
before plugging in
G Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
G
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Wash the parts: see 'care and clean-
ing'.
2 Wind excess cord around the motor
base and secure in the slot provided
.
manuals search engine

English

key
power unit
lid with operating button
blade assembly (fixed)
cord stowage
to grind beans
1 Place up to 50g/2oz of coffee beans
into the coffee mill. The lid can be
used as an approximate measure .
2 Place the lid on the unit so that the
button is positioned above the
Kenwood name. It will not fit in any
other position but will drop easily
into place when correctly located.
3 Connect to the power supply and
switch on the appliance by depress-
ing the button in a continuous oper-
ation or a series of pulses until the
desired consistency is achieved .
This will vary according to the quan-
tity of coffee ground and the degree
of roasting.
4 Lift the lid to remove.
5 Use the ground coffee as required.
Important:
If the lid is removed to check the
consistency of the coffee grounds,
always ensure that the inner rim is
free of coffee particles. This can be
carried out by shaking the grounds
into the centre . Failure to do this
may prevent the appliance from
operating. If this is the case, remove
the lid, clear the grounds from the
rim as above, replace the lid.
Always ensure that the blades have
stopped revolving before removing
the lid of the coffee mill.
2