6�1 Electrical Design Of The Output Stage; Display - autosen AD008 Bedienungsanleitung

6.1 Electrical design of the output stage
► Observe the electrical design of the type used:
Type Electrical design
AD008
Pin 2 and pin 5 of the IO-Link device (connection (3) (→ 6)) are connected
through to the installation side (4) in the Y cable AA047. So for IO-Link
devices with a signal on pin 2 (e�g� second switching output or analogue
output) this signal is passed on unchanged to the installation.
Connections (1) and (2) of the data splitter are electrically isolated (A).

7 Display

Fig� 7�1
1: LED 1 (yellow); indication of the switching status OUT1, if available
2: LED 2 (green); operation display / fault
3: LED 3 (yellow); indication of the IO-Link communication (→ 9.1)
PNP
1 2
Output logic (general)
3
L +
L
UK
25