Installation Steps - Weelko META Bedienungsanleitung

CONTENT
Please check that there are no missing
parts when you receive the parcel:
-Foot SPA basin

INSTALLATION STEPS

In order to install the foot spa basin, fo-
llow the next steps:
• Open the packaging, insert the shower
to the water pipe showed and tighten it
to prevent leakage. (as Fig.1)
• Place the metal upper cup (Fig.2) into
the small square plastic pipe. Insert the
Allen screw and tighten it with the Allen
key. Put the stopper as in the scheme
below. (Fig.2)
Metal upper cap
Cover hole
Switch cold & hot water
Square plastic pipe
Allen screw
Stopper
Fig.2
EN
Hot water inlet
Cold water inlet
Shower
Water pipe
Fig.1
Allen key
• Connect the hot and cold water hole to
the hot and cold water pipe, and tighten
them to prevent leakage. (as Fig. 3)
• Insert/connect the drain of the foot
basin into the underground drainage pit.
(as Fig. 3)
• Connect the power cord into the power
box, then you can put the foot basin into
use. (as Fig. 3)
Fig.3
INSTRUCTIONS FOR USE
Blocking wheels
Importer: Weelko Barcelona, S.L.
Power cord
Shower
© 2020 Weelko
www.weelko.com
ESB65397556