Operating The Hot Water Dispenser - KLARSTEN Caldetto Bedienungsanleitung

Important notes on coffee preparation
• The device is equipped with an anti-drip function. During the brewing process you
can temporarily remove the glass carafe and pour out the coffee. When pouring
coffee from the glass carafe, pour it out slowly.
• Do not suddenly tilt the glass carafe at a large tipping angle, as hot coffee can flow
out of the lid rim and injure people.
• Do not place an empty glass carafe on the hot hot plate.
Setting the time and starting time
To set the current time: Press the [00: --] button to set the current hour, press the
1
[--:00] button to set the current minute.
While holding down the
2 the desired start time (AM or PM). Then release the button and the start time is
set. The display returns to the current time.
Press the button , the light will turn green and the stored start time is
3
activated. Press the button again to cancel the function.

OPERATING THE HOT WATER DISPENSER

Open the container lid of the hot water dispenser and fill the tank with cold
1
water. Do not fill the water above the MAX line.
Close the lid. Press the [I/O] button to heat the water. The button lights up blue,
the symbol flashes on the display and the water starts to heat up. When the
2
water is boiling, the ready indicator lights up green. The water remains hot for
2 hours, after which the appliance switches off automatically and goes into
standby mode.
Press your mug, cup or glass against the hot water lever to release hot water.
Note: If the "FIL H2O" symbol appears in the display, it means that there is no
3
water in the hot water tank of the hot water dispenser. Fill the tank. If you want
to fill the tank during operation, first turn off the appliance and then fill it with
clean water.
button, press the [00: --] and [--:00] buttons to set
EN
19