Weelko WIND WKP006 Bedienungsanleitung Seite 8

OPERATION INSTRUCTIONS
6. Check the handpiece direction of
rotation when switching the device on.
7. Switch the device off with the
footswitch to check if it is working pro-
perly.
8. Use Left/Right to select the direc-
tion of rotation to the left or to the right.
Switch the device on to check if both
directions are working properly.
9. Once the device is well configured,
the treatment can be started.
10. To change the drill, turn the han-
dpiece as shown in the pictures below
with the help of the part supplied to
remove it.
CAUTIONS
* Do not use a rusted or twisted drill.
* Gradually increase the device speed.
* Never change the drill when the han-
dpiece is working. The drill chuck must
be opened only when the handpiece is
completely stopped.
EN
* Handle the handpiece with care. Drops
or impacts could damage the internal
components and affect its functioning.
Should they occur, please check first the
functioning of the device at minimum
speed.
* If the engine stops suddenly, check the
fuse and avoid electric overload.
* Keep the handpiece always with a
mounted drill and make sure it is bloc-
ked.
* Use only compatible accessories with
this device. Follow the recommendations
made by the drill manufacturer regarding
caution and recommended speed.
* Use task-specific clothing and equi-
pment, including safety glasses and
face shield visor against fine dust. Use
a powerful vacuum cleaner to prevent
dust buildup.
* Keep your workplace clean and free
from other objects to work under good
conditions.