Maintenance; Disposal; Calibration And Warranty - wavin DUO 315 Betriebsanleitung

11 Maintenance

RoHS Compliant
Directive 2005/ 95/ EC
Pb
10
11 Maintenance
Regularly check for obvious defects such as loose or damaged cables
and connectors. Look for warn components and broken covers or
housings.
There are no user serviceable parts inside the unit. It should be returned
to an approved service agent for repair and calibration.
It is recommended that the unit is calibrated every twelve months.
After use, clean the outside of the unit with a soft brush or cloth.
Carefully wind up and store the cables in the protective case.

12 Disposal

DO NOT DISPOSE OF THIS EQUIPMENT INTO HOUSEHOLD
WASTE !
According to the European Directive 2002/96/EC Waste Electrical and
Electronic Equipment (WEEE), when no longer suitable for use, this
equipment must be separately collected and sent for recycling
According to the European Directive 2005/95/EC Restriction of
Hazardous Substances (RoHS), this equipment does not contain more
than the agreed levels of lead, cadmium, mercury, hexavalent
chromium, polybrominated biphenyl (PBB) and polybrominated diphenyl
ether (PBDE) flame retardants.

13 Calibration and Warranty

This welding unit has been manufactured, inspected and tested in
accordance with the quality control systems in place at Advance
Welding.
This welding unit has been calibrated using equipment that is traceable
to national and international standards, through a NAMAS accredited
laboratory. NAMAS (National Accreditation of Measurement and
Sampling) is a service of UKAS (United Kingdom Accreditation Service).
This welding unit has a TWELVE month calibration and warranty period,
active from the first use of the unit by the end user customer.
(05.11)
KS_DUO 315_BA_04_701474600_00.doc
Operating instructions DUO 315