AEG MC 4451 iP Bedienungsanleitung Seite 15

5 FUNCTION (function switch)
6 STANDBY Indicator
7 IR sensor for the remote control
8 VOL +/- buttons
9 PRESET EQ button
10 SNOOZE button
11 ALARM button
12 DISPLAY/ID3 button
13 LCD display
14 PLAY MODE button (Repeat/Random play)
15 MEM/CLK-ADJ. button (memory/clock)
16 FOLDER/PRE (Folder/Preset Up) button
17 TUNE+ / TUNE– buttons (search forward/
backwards)
18 button (play/pause)
19 headphone jack
20 ST/MO button (Stop / Stereo/Mono)
21 (Open/Close) CD compartment
22 CD compartment
Side of unit (not shown)
DC 9V Connection
FM ANT. aerial antenna
AUX-IN connection
SPEAKER R/L Speaker connections
Subwoofer (not shown)
Operating status indicator
Mains cable
Mains switch (POWER ON/OFF)
Volume control (SUBWOOFER VOL)
Remote control
1 FUNCTION (function Selection button)
2 (play/pause) button
3 FOLDER/PRE / / i-MENU / i-ENTER buttons (up/
down, album/ radio memory position / iPod/iPhone
Menu/Enter)
4 +10 /-10 / i-SCROLL / buttons
5 button (Open/Close)
6 i-REPEAT button
7 PLAY MODE button (Repeat/Random play)
8 DISPLAY/ID3 button
9 SLEEP button
10 PRESET EQ button
11 MUTE button
12 SNOOZE button
13 ALARM button
14 i-SHUFFLE button
15 VOL +/- buttons
16 MEM/CLK-ADJ. button (memory/clock)
/TUNE+ button (search forward)
/TUNE– button (search backwards)
(Stop / Stereo/Mono) button
17 / button
Installation/Introduction
• Read the manual thoroughly before operating the
device!
• Select a suitable location for the unit and speakers.
Suitable locations are dry, even and anti-slip surfaces
on which you may operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
Wall mounting
You can also mount the device to the wall (mounting
accessories not supplied).
CAUTION:
Make sure beforehand whether there are cables in the
wall which could be damaged!
NOTE: Check the reach of the cable!
To mount the device, make sure that an easily accessible
plug outlet is available within reach of the power cable.
• Align the hole template horizontally and mark the drill
holes required for wall mounting.
• Drill the mounting holes.
• Fit rawlplugs and screws into the holes.
• Tighten the mounting screws until they protrude
around 4 mm from the wall.
• Attach the unit and speakers onto the screws. Check
that it is secure.
Assembling the stand
• Insert the unit and the two speakers onto the stands
and tighten the mounting screws.
ENGLISH
15