Programming/Initial Commissioning Using The Quick-Programming Function; Fitting The Lights; Programming The Remote Control - Koch FUS5 Bedienungsanleitung

1.

Programming/initial commissioning using the quick-programming function

1.1

Fitting the lights

1
1
1
1.2

Programming the remote control

1
1
2
2
2
513643-E
4-channel remote control (FUS5)
for 1-channel remote dimmer (LFDQ)
for 1-channel dual remote dimmer (LTDQ)
Fit the lights in accordance with the installation guide provided with the
furniture.
Plug all lighting systems that are to be programmed to button 1 of the remote
control into the mains.
When the lights flash continuously, the dimmer is ready to be programmed.
All connected lights flash.
1
Press button 1 on the 4-channel remote control.
When the lights are illuminated continuously, programming has been
completed successfully.
Note:
When programming is complete, the quick-programming function is deactivated
for this button but it can be reactivated by the selective factory reset.
Proceed in the same manner for buttons 2, 3 and 4.
The central button is programmed to switch all lights on and off (see section
2.4).
Note:
1-channel wireless dimmer:
The center button is designed for the "all lights on / off" function (see section
2.4.1).
1-channel wireless tandem dimmer:
The center button is designed for the "all lights on / off" function and color
change (see section 2.4.2).
578185
1
AN-06687-A/KOC-EL 12