AEG MC 4448 DVD Bedienungsanleitung Seite 62

ENGLISH
62
Video Setup
3D Processing Page
DSP Mode
With the "DSP Mode" function it is possible to produce surrounding
acoustics similar to those found in a concert hall or church.
Video Output
Select the video output option for the playback device that is connected
and which you wish to use. Choosing the right signal format depends on
the type of connection and the playback device (see also the operating
manual of the replay unit).
K
CVBS: Select this option if your playback device is connected to the
DVD player via the composite video and/or S-video connection.
K
YPbPr:
Select this option if your playback device is connected to the
DVD player via the component video connection.
K
RGB: Select this option if your playback device is connected to the
DVD player via the SCART connection.
NOTE:
If you would like to select the "RGB" setting, please ensure that your
playback device supports this setting.
TV Display
Here you can adapt the output of the DVD-Player to the TV-aspect.
Concerning the background: If you do not have a wide screen TV the TV-
aspect will be 4:3. However, most feature films have an aspect of 16:9,
the image is therefore too wide for the TV-screen.
Here you can specify how the replay of the film is to be adapted to the
playback device:
K
4:3 Panscan: You will only see the middle section of the film. The bor-
ders will be cut off.
K
4:3 Letterbox: You will see the complete width of the film. The film is
thus reduced in size, whereby black bars appear below and above the
film.
K
16:9 WIDE: Select this option if you use a wide screen TV for replay.
Please note that films, that have been recorded with TV-aspect 4:3
can still be replayed using aspect 4:3. This means, that replaying this
film will not require the complete wide screen area of the television.
NOTE:
The setting "4:3 Panscan" is not supported by all DVDs.