Downloaded from
www.Manualslib.com
t R o u B l E S h o ot I n G
Your Vitamix motor is designed to be protected from overheating and overcurrent
conditions during use. Both features will shut off the motor. The motor will
possibly emit a slight odour. Follow the procedures below to reset the motor
for either situation. If you continue to experience problems after following these
instructions, contact your local distributor immediately for instructions.
Overheating Protection Resetting Procedure
If the motor shuts off due to overheating while blending, allow the machine to cool
for 20-45 minutes before beginning another blending cycle. If the motor will not
start after being allowed to cool, perform the Automatic Overcurrent Protection
Resetting Procedure below.
Overcurrent
Protection
Resetting Procedure
1.
Push the On/Off switch down
to the Off position (O).
2.
Unplug the unit.
3.
Remove the container.
4.
Turn the motor base on its side.
5.
Press the reset button on the
bottom of the machine.
6.
Plug unit in and continue with
the blending cycle.
If the blender will not start immediately,
the motor has overheated. Allow the
motor to cool for 20-45 minutes before
beginning another blending cycle.
Tips to prevent
"overloading" your
Vitamix machine:
•
Only process Vitamix recipes when learning to use the machine
•
Do not process recipes at lower speeds than those recommended
•
Do not process recipes at higher speeds than those recommended
•
Do not process recipes for longer than recommended
•
Use your tamper to process thicker mixtures and keep ingredients moving
around and through the blades
manuals search engine
Front
Back
47