Cpu Installation - ASROCK FM2A75 Pro4-M Handbuch

2.1 CPU Installation

Step 1. Unlock the socket by lifting the lever up to a 90
Step 2. Position the CPU directly above the socket so that the CPU corner
Step 3. Carefully insert the CPU into the socket until it fits in place.
Step 4. When the CPU is in place, press it firmly on the socket while you
2.2 Installation of CPU Fan and Heatsink
Downloaded from www.Manualslib.com
with the golden triangle matches the small triangle on the socket's
corner.
The CPU fits only in one correct orientation. DO NOT force
the CPU into the socket to avoid bending of the pins.
push down the socket lever to secure the CPU. The lever clicks
on the side tab to indicate that it is locked.
Lever 90° Up
STEP 1:
Lift Up The Socket Lever
After you install the CPU into this motherboard, it is necessary
to install a compatible heatsink and cooling fan to dissipate heat.
You also need to spray thermal grease between the CPU and
the heatsink to improve heat dissipation. Make sure that the
CPU and the heatsink are securely fastened and in good con-
tact with each other. Then connect the CPU fan to the CPU FAN
connector (CPU_FAN1, see Page 2, No. 5 or CPU_FAN2, see
Page 2, No. 6). For proper installation, please kindly refer to the
instruction manual of the CPU fan and the heatsink.
ASRock FM2A75 Pro4-M Motherboard
manuals search engine
CPU Golden Triangle
Socket Corner Small
Triangle
STEP 2 / STEP 3:
Match The CPU's Golden
Triangle To The Small
Triangle on the Socket's
Corner
o
angle.
STEP 4:
Push Down And Lock
The Socket Lever
17