KeySonic ACK-540 RF Bedienungsanleitung Seite 11

1.3 Installation of keyboard
• Recommended requirement for that is the successful installation of the USB receiver under point 2.2
• If you haven't done yet, remove the covering of the battery case on the bottom of your keyboard. Install
the included batteries of type AAA 1.5 V considering the right polarity in the battery case (see picture).
• The USB receiver and the keyboard are factory-made already synchronised on the same channel.
Normally you have not to make a new-synchronisation (as described under point 2.4).
• Now you can check this by pressing any key of your
keyboard. If you press the Windows key, there has to open
for instance the Windows Pop-up menu down left on your
screen. If so, your wireless keyboard is working correctly
now. If not, please synchronise the USB receiver and the
keyboard again like described under point 2.4.
Advise:
Should the functionality be influenced by other users applying their wireless keyboard close-by, make
also a new-synchronisation as described under point 2.4.
2.4 New-synchronisation of the radio channel
• When you start up your keyboard and no connection could be established,
so synchronise the radio channel between keyboard and USB receiver
again by pressing firstly the SW key on the USB receiver with a sharp
object (for instance a ball-pen).
• Press now within the next 3 seconds the key
keyboard for more than 1 second by which the synchronization-signal is
sent to the USB-Receiver.
The keyboard is ready for use now.
Please check it as described under point 2.3.
Advise:
Should the
3 seconds, so turns the USB receiver without previous new-
synchronisation back to the condition of origin.
Version 1.1 (2008/06/05) ● © 2008 by MaxPoint Handelsges. mbH
Downloaded from www.Manualslib.com
Fn key on your keyboard not be pressed within
manuals search engine
4
×
below on the left of the
Fn
- 9 -
SW key