Werbung
INSTALLATION
1. Loosen the two thumb screws (one on each side)
several turns and remove the mounting bracket
from the speaker.
2. Temporarily position the speaker and the
mounting bracket to verify the desired mounting
location. Make sure the speaker will not interfere
with the desired operation of the vehicle
(preferable placement is on the passenger side of
the vehicle) and that the speaker front is not
blocked by sound absorptive material. Using the
mounting bracket as a guide, mark two holes on
the transmission hump or other selected location.
3. Using an awl or other similar device, open two
holes in the carpet at the marked locations. This
must be done prior to drilling to avoid ruining the
carpet.
4. Using a 3.2mm (1/8)" bit, drill the two mounting
holes and secure the bracket using the two 8-18 x
3/4" tapping screws and washers provided.
5. Mount the speaker to the mounting bracket.
Ensure that at each mounting position, the self-
adhering insulating washer is on one side of the
bracket and the insulating washer is on the
bracket as shown in Figure 3. Securely tighten the
two thumb screws.
6. Route wires through connector as shown in
Figure 1a, or for applications with multiple
accessories connected to the mobile radio, route
wires as shown in Figure 1b and use the cable tie
2
Werbung
