Werbung
Acro Wot Foam-E Instructions / Acro Wot Foam-E Anleitung
Radio Installation
The Acro Wot ARTF is supplied without transmitter
or receiver. Connect the factory installed servos to your
choice of receiver. Connect the electronic speed controller
to the receiver's throttle channel.
The Acro Wot ARTF is supplied without transmitter
or receiver. Connect the factory installed servos to your
choice of receiver. Connect the electronic speed controller
to the receiver's throttle channel.
The receiver can now be attached to the radio bay
floor with Velcro or double sided tape. Install an aileron
extension lead if required, although the supplied aileron
Y-lead should be sufficient.
The receiver can now be attached to the radio bay
floor with Velcro or double sided tape. Install an aileron
extension lead if required, although the supplied aileron
Y-lead should be sufficient.
The Acro Wot FTR is supplied with a
factory installed S-FHSS receiver that is
compatible with Futaba 2.4GHz S-FHSS
radio systems such as the 6J, 8J and 18MZ.
The Acro Wot FTR is supplied with a
factory installed S-FHSS receiver that is
compatible with Futaba 2.4GHz S-FHSS
radio systems such as the 6J, 8J and
18MZ.
Binding Procedure
If the receiver is not bound to a transmitter, the LED
inside will glow RED when a Li-Po is connected.
With no battery connected, insert the bind plug
(supplied) into the receiver output marked
Connect your Li-Po battery to power up the receiver.
The LED will flash alternate RED and GREEN.
on your transmitter. Once bound, the LED will glow solid
GREEN.
Unplug the Li-Po battery, switch off the
transmitter and remove the bind plug. The receiver is
now bound. Now turn on the transmitter then connect
the Li-Po. The LED inside the receiver will glow GREEN.
If the receiver is not bound to a transmitter, the LED
inside will glow RED when a Li-Po is connected.
With no battery connected, insert the bind plug
(supplied) into the receiver output marked
Connect your Li-Po battery to power up the receiver.
The LED will flash alternate RED and GREEN.
on your transmitter. Once bound, the LED will glow solid
GREEN.
Unplug the Li-Po battery, switch off the
transmitter and remove the bind plug. The receiver is
now bound. Now turn on the transmitter then connect
the Li-Po. The LED inside the receiver will glow GREEN.
ARTF
.
Turn
.
Turn
7
Werbung
